Home > NEWS&FAQ > Content

CNC Machining Center Requirements For Use Of The Environment

Jun 24, 2019

The use of CNC machining centers must meet the following four conditions:

 

First, the location and environment requirements of the machining center

 

The machining center should be located away from the vibration source and should be protected from direct sunlight and heat radiation to avoid moisture effects and airflow.

If there is a vibration source near the CNC machine, an anti-vibration groove should be installed around the machining center.

Otherwise, it will directly affect the machining accuracy and stability of the CNC machining center, resulting in poor contact of electronic components, leading to failures and affecting the reliability of the machining center.

 

Second, the power requirements

 

The general machining center is installed in the machine shop, which not only has large changes in ambient temperature, but also has poor operating conditions and various electromechanical devices, resulting in large fluctuations in the power grid.

Therefore, the position of the machining center requires strict control of the power supply voltage.

Power supply voltage fluctuations must be within the allowable range and remain relatively stable.

Otherwise it will affect the normal operation of the machining center CNC system.

 

Third, the temperature conditions

 

The CNC machining center has an ambient temperature of less than 30 degrees and a relative temperature of less than 80.

Under normal circumstances, the numerical control electric control box is internally provided with an exhaust fan or a cooling fan to keep the electronic components, especially the central processing unit, at a constant operating temperature or a small temperature difference.

Excessive temperature and humidity can result in reduced life of control system components and increased failure.

As temperature and humidity increase, an increase in dust can cause the integrated circuit board to bond and cause a short circuit.

 

Fourth, follow the instructions to use the machining center

 

When used in the machining center, the user is not allowed to arbitrarily change the parameters set by the manufacturer in the control system.

The setting of these machining center parameters is directly related to the dynamic characteristics of the various components of the machining center.

The value of the gap compensation parameter can only be adjusted according to the actual situation.

 

The above is based on years of experience and sharing by ALLES CNC machining center manufacturers. As a member of the CNC industry, ALLES CNC is the thinker of CNC machine tools. It is consistent and consistent, choose ALLES, you can rest assured. ALLES's 24-hour online quality service is looking forward to your inquiry. (Please click on SHADONG ALLES ENERGY TECHNOLOGY CO.,LTD)


CNC machining center requirements for use of the environment

More details: www.allescncmachine.com

Whatsapp: + 86-15966602397(24 hours online)